Well Pump Services in Scarborough

If your well pump stopped and you have no water, check the breaker for the pump first — a tripped breaker or GFCI is the most common cause and takes a second to reset. If it trips again right away, leave it off and call us: that points to a shorted motor or wiring. Also check that the pressure switch contacts aren't stuck open. Beyond that, the fault is usually the switch, the control box capacitor, or the pump itself, and we can diagnose all three on a same-day visit anywhere in Scarborough.

Well pump repair in Scarborough is a same-day call for us, because a house on a well with no water has no toilets, showers, or kitchen either. We cover the private-well properties along the Rouge valley and north Scarborough, plus neighbouring communities, and the truck carries pressure switches, tanks, and common submersible pumps so most repairs are finished on the first visit.

A well pump that turns on and off constantly — short cycling — almost always means the pressure tank has lost its air charge or the bladder has failed, so there's no cushion and the pump starts every time a tap opens. It can also be a leaking check valve or a pressure switch set too tight. Short cycling burns out a pump motor fast, so it's worth fixing early: a new tank or switch is a fraction of the cost of well pump replacement.

A submersible well pump typically lasts 10–15 years; a jet pump somewhat less, and either one dies sooner if it's been short cycling or pumping sand. Replace the pump when the motor has failed, when it can no longer reach cut-off pressure, when repairs are stacking up on a unit past ten years, or when it's undersized for the household it now serves. We give you a repair price and a well pump replacement price side by side so the decision is yours.

A well pump installation from us starts with sizing: well depth, static water level, yield, and your household's peak demand determine the horsepower and stage count. For a submersible we pull the old pump, inspect the drop pipe, wire, check valve, and pitless adapter and replace anything worn, set the new pump with a torque arrestor, and reconnect. We then set or replace the pressure tank and switch, pressure-test the system, check flow at the furthest fixture, and leave you a written record of the model, depth, and settings.

Yes — low water pressure on a well is usually fixable, and often without a new pump. The first steps are checking the tank's air charge, raising the pressure switch setting if the pump can support it, and clearing a clogged intake screen or sediment filter. For homes with several bathrooms or irrigation, a constant-pressure controller holds steady, city-like pressure no matter how many taps are open. We'll test what your pump can actually deliver before recommending any upgrade.